Hydraulic Low Level 2000kg Car Lift Transmission Jack CE Approved

2tons Low Level Transmission Jack

First, the basic function

The hydraulic lift conveyor is the introduction of foreign prototype, combined with the domestic automobile repair and maintenance industry requirements and characteristics of careful design.It is mainly used for the high installation and disassembly of automobile gearbox, engine, transmission motor, front and rear axle and other objects whose weight does not exceed 2T. It is an indispensable lifting and transporting tool for automobile repair and maintenance factory. It is the supporting equipment of column or shear type automobile lifting equipment.At the same time the hydraulic lifting conveyor is also suitable for cooking.

Two, use method

1, with the pillar or scissor lift to lift the car to a certain height.

2, Push the hydraulic lift under the car, and lift the hydraulic lift to the appropriate position, and remove the objects to be repaired (such as:Gearbox, engine, drive shaft, front and rear axle, etc.) are placed in the center of the bracket, and then the object is fastened with steel chain, and the unloading valve is opened.Put what the bracket and objects.

3, Push the hydraulic lift to the desired position.Under the object with the crane maintenance.

4, After the object is repaired, lift the object with the crane and put it in the center of the bracket, and fasten the object with the steel chain.Ship lifter driven fluid pressure in appropriate places under the car

5, close the unloading valve, step on the oil pump, lift the object to the appropriate position, install the object, such as the object position is not right, you can move the hydraulic lift or through the adjusting hand wheel under the bracket to adjust.

Our products mainly include electric oil, gear oil pump series, spanner, tow rope, high pressure gas cylinder, high and low position conveyor, pneumatic oil injector injector.

Do we accept customization?

Yes, we can accept customization.

Can you help us to do some change about your product?

Yes, special drawing and design will be evaluated by our technical department, unit cost will be calculated by finance department for your final confirmation. All procedures will be informed and confirmed with you in advance.

Can I get a sample?

Yes. Samples are welcome to us before mass production. But few extra cost and products cost will be charge from customer first, and sample cost will be back to customer once started mass production.You need to pay the express fee.

Are you a factory or trading company?

xianxian zhongtuo hardware tools co.,LTD is specialized in the production and development of automobile repair tools,equipment and sales as one of professional manufacturers.